slayeroftrolls wrote:
Be sure to post a picture of the cast! It sounds very interesting!
Will do once I start a WIP
| The One Ring http://test.one-ring.co.uk/ |
|
| using gs and instantmoulds http://test.one-ring.co.uk/viewtopic.php?f=20&t=27507 |
Page 1 of 1 |
| Author: | army-of-the-dom [ Fri Jan 17, 2014 6:48 pm ] |
| Post subject: | using gs and instantmoulds |
So i have made a mould using instant mould of efgt scenery for my goblins bases, i have pressed the gs into the mould and i dont know whether i have to leave it in the mould to harden for 24 hours or if i can take it out after a 5 minute pressing period and the gs wont just lose the detail, sinking back to a useless pice of hard gs. thanks in advance! |
|
| Author: | SidTheSloth [ Fri Jan 17, 2014 6:58 pm ] |
| Post subject: | Re: using gs and instantmoulds |
Unless you're using a lot of lubricant I certainly would recommend taking it out of the mold before at least about 2 hours pass. |
|
| Author: | army-of-the-dom [ Fri Jan 17, 2014 7:05 pm ] |
| Post subject: | Re: using gs and instantmoulds |
ok, good thing i took mine out i was just worried the detail would sink awy, thanks as always Sid! |
|
| Author: | slayeroftrolls [ Fri Jan 17, 2014 7:14 pm ] |
| Post subject: | Re: using gs and instantmoulds |
Be sure to post a picture of the cast! It sounds very interesting! |
|
| Author: | army-of-the-dom [ Fri Jan 17, 2014 7:55 pm ] |
| Post subject: | Re: using gs and instantmoulds |
slayeroftrolls wrote: Be sure to post a picture of the cast! It sounds very interesting! Will do once I start a WIP
|
|
| Author: | Ukfreddybear [ Fri Jan 17, 2014 8:05 pm ] |
| Post subject: | Re: using gs and instantmoulds |
You shouldn't need to use any lubricant if it is instant mold you are using. The details in Green stuff will certainly soften more the sooner you remove it, but if it is only planks then you probably wont notice too much. |
|
| Author: | Hodush [ Fri Jan 17, 2014 9:13 pm ] |
| Post subject: | Re: using gs and instantmoulds |
As ukfb said - shouldn't need lubricant and taking it out before it is set might ruin some of the detail. |
|
| Author: | SidTheSloth [ Fri Jan 17, 2014 9:57 pm ] |
| Post subject: | Re: using gs and instantmoulds |
Oh I see... I thought you said GS... my bad  heheh
|
|
| Author: | army-of-the-dom [ Fri Jan 17, 2014 9:58 pm ] |
| Post subject: | Re: using gs and instantmoulds |
Haven't used any lubricant and details look great taken progress pics but in no means a tutorial as it may seem... |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|