I don't have it in my hands yet but I got this miniature from someplace. The sword of the castellan is a bit bent. What is the best way to straighten it?
| The One Ring http://test.one-ring.co.uk/ |
|
| how to straighten the bent metal models http://test.one-ring.co.uk/viewtopic.php?f=30&t=27135 |
Page 1 of 1 |
| Author: | farinal [ Mon Dec 23, 2013 3:01 pm ] |
| Post subject: | how to straighten the bent metal models |
I don't have it in my hands yet but I got this miniature from someplace. The sword of the castellan is a bit bent. What is the best way to straighten it? |
|
| Author: | Bofur The Dwarf [ Mon Dec 23, 2013 3:06 pm ] |
| Post subject: | Re: how to straighten the bent metal models |
I usually straighten it with my fingers. But be careful if you're planning on doing this, if it's bent backwards and forwards several times it's gonna snap  Personally though, I find this the best way. It's probably the easiest way too 
|
|
| Author: | Gene Parmesan [ Mon Dec 23, 2013 3:43 pm ] |
| Post subject: | Re: how to straighten the bent metal models |
I use two lolipop sticks or coffee stirers, and pinch the bent item straight. I don't know if it'll make sense without photos. I'll see if I can get some done. Whatever you do, be careful not to over do it. 
|
|
| Author: | Gene Parmesan [ Mon Dec 23, 2013 4:22 pm ] |
| Post subject: | Re: how to straighten the bent metal models |
I've used Jenga in place of lolipop sticks First off you want to get the weapon all bent in the same direction so pinch the weapon one side of the bend and draw it all round in the same arc.  Should end up like this  from here we can place the weapon back between the wood, and apply some mild pressure to straighten out the bend.  carefully repeat this method as neccessary, using one stick as a flat edge, and the other as a lever. voila 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|